see iSCSI Setup forĭetails on that initial configuration. The iSCSI subsystem to obtain a /dev/sdX file. *2 - Will not detect, out of the box, an iSCSI drobo. Run a drobo-utils in line mode on the droboshare itself. #2.6.4 drobo dashboard droboapps forum install#Install Droboshare Augmented Root File System ( DARFS) then one can *1 - Droboshare is not usable with drobo-utils on a linux server. N/a - not applicable (device does not have this interface.) theįull - Find/Full: drobo-utils will find the device on it's own (auto-discover)ĭata - works: device functions for data i/o, but Drobo-utils cannot access it for configuration. With that in mind, the compatibility matrix of each device vs. Write data, and full meaning that the drobo responds to the full There are two levels of access to Drobos: data (being able to read and Even for the sameĭevice, different physical interconnects may work with different functionality. Unfortunately, the way Drobos respond varies, so not all of them respond Scans those files, and asking each device if it is a Drobo. Read & write data to it using ordinary system tools (see Setup.)ĭrobo-utils accesses drobos via the same files. If you can get your drobo device to be associated with a /dev/sdX įile, then you will be able to partition, build file systems and So that is where drobo-utils, the linux dashboard, comes in. If you have a problem, the vendor might ask you to produce a diagnostics file.Need in order to configure it properly for use. For DroboPro, there are many settings (ip address?) one might.To change the drobo's settings from their defaults (like a 2 TiB LUN size).To see information about the hard drives in the Drobo without taking them out.Verifying if new firmware available, and update installing it.If the drobo is hard to see Drobo, the software can replace the lights on.Just feed it drives when it asks, and that is all. When it gets too full, Drobo will ask for anotherĭrive with its drive lights. The blue capacity lights willįill up as the disks fill. You can use Drobos without any special software. Manually setting things up from the command line without any special software.įor those with other tastes, there is also a GUI that can take care of it: Plug it in like any USB thumb drive.įor old Linux hands, just use a partitioner, such as parted, and build an ext3įile system and set the mount point. Really! It can be used just as a normal disk. So you bought a Drobo and want to use it under linux. It pretends to be justĪ pile of storage, and does the smart thing. Nor are arcaneĭecisions about how the data is laid out asked. With other storage units, have to install matching disks. #2.6.4 drobo dashboard droboapps forum how to#Of figuring out how to maximally protect from data loss.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |